Dunbar Plumbing Forums - Northern Kentucky's 1st DIY Plumbing Forum

PLUMBING - CODES, PRODUCTS, EQUIPMENT AND PRACTICES => Drain Cleaning Equipment => Topic started by: JERRYMAC on January 16, 2010, 07:50:37 PM

Title: HOW TO SPLICE INNER CORE SEWER CABLE
Post by: JERRYMAC on January 16, 2010, 07:50:37 PM

GO TO GORLITZ SEWER AND DRAIN AT THIS LINK
TO GET CABLE SPLICERS

http://www.gorlitz.com/index.php?act=viewDoc&docId=36

YOU PULL THE INNER CORE ON EACH SIDE A FEW INCH'S
THEN CUT OFF THIS IS TO MAKE ROOM FOR SPLICE
OF COURSE YOU DON'T HAVE THIS PROBLEM WITH A GOOD NO CORE CABLE
NEED (2) TWO PAIRS OF VISE GRIPS
HOLDING CABLE WITH ONE USE A 3/8" CENTER PUNCH TO SPREAD THE CABLE A LITTLE BIT
THEN USEING A LITTLE LOCKTITE ON THE MALE SPLICE THREADS ONE SIDE ONLY TO START INTO THE END OF CABLE
IMPORTANT ONLY JUST GET STARTED INTO CABLE
THEN GRIP WITH ONE PAIR OF VISE GRIPS
WITH (2) SECOND PAIR GRIPPING THE OTHER CABLE GET IT STARTED
AND SLOWLY SCREW BOTH SIDES TOGETHER TILL THEY MEET !

THAT IS HOW  PROFESSIONAL  DRAIN PEOPLE DO IT


__________________

Title: Re: HOW TO SPLICE INNER CORE SEWER CABLE
Post by: saysflushable on January 17, 2010, 03:50:39 PM

   Hey Jerry did you only run inner core?     I run non inner core now.     How easy did the cable inside the inner core pull out?

Title: Re: HOW TO SPLICE INNER CORE SEWER CABLE
Post by: JERRYMAC on January 17, 2010, 05:29:07 PM

YES ALMOST ALL THE CABLE THAT I DID THIS ON WAS HOLLOW CORE CABLES FROM 3/8" 13/32" 1/2" 5/8" 11/16" & 3/4"