1
Drain Cleaning Equipment / Re: HOW TO SPLICE INNER CORE SEWER CABLE
« on: January 17, 2010, 05:29:07 PM »YES ALMOST ALL THE CABLE THAT I DID THIS ON WAS HOLLOW CORE CABLES FROM 3/8" 13/32" 1/2" 5/8" 11/16" & 3/4"
Dunbar Plumbing Forums - Northern Kentucky's 1st DIY Plumbing Forum
- November 23, 2024, 06:52:09 AM
- Welcome, Guest
News:
CALL DUNBAR PLUMBING 859-359-4833 WWW.DUNBARPLUMBING.COM
- Dunbar Plumbing Forums - Northern Kentucky's 1st DIY Plumbing Forum >
- Profile of JERRYMAC >
- Show Posts >
- Messages
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
YES ALMOST ALL THE CABLE THAT I DID THIS ON WAS HOLLOW CORE CABLES FROM 3/8" 13/32" 1/2" 5/8" 11/16" & 3/4"
2
Products Used in Plumbing / Re: Who's using Map Gas?
« on: January 16, 2010, 08:24:48 PM »Mapp gas for the hand torch. B-tank for everything else
3
Drain Cleaning Equipment / HOW TO SPLICE INNER CORE SEWER CABLE
« on: January 16, 2010, 07:50:37 PM »
GO TO GORLITZ SEWER AND DRAIN AT THIS LINK
TO GET CABLE SPLICERS
http://www.gorlitz.com/index.php?act=viewDoc&docId=36
YOU PULL THE INNER CORE ON EACH SIDE A FEW INCH'S
THEN CUT OFF THIS IS TO MAKE ROOM FOR SPLICE
OF COURSE YOU DON'T HAVE THIS PROBLEM WITH A GOOD NO CORE CABLE
NEED (2) TWO PAIRS OF VISE GRIPS
HOLDING CABLE WITH ONE USE A 3/8" CENTER PUNCH TO SPREAD THE CABLE A LITTLE BIT
THEN USEING A LITTLE LOCKTITE ON THE MALE SPLICE THREADS ONE SIDE ONLY TO START INTO THE END OF CABLE
IMPORTANT ONLY JUST GET STARTED INTO CABLE
THEN GRIP WITH ONE PAIR OF VISE GRIPS
WITH (2) SECOND PAIR GRIPPING THE OTHER CABLE GET IT STARTED
AND SLOWLY SCREW BOTH SIDES TOGETHER TILL THEY MEET !
THAT IS HOW PROFESSIONAL DRAIN PEOPLE DO IT
__________________
TO GET CABLE SPLICERS
http://www.gorlitz.com/index.php?act=viewDoc&docId=36
YOU PULL THE INNER CORE ON EACH SIDE A FEW INCH'S
THEN CUT OFF THIS IS TO MAKE ROOM FOR SPLICE
OF COURSE YOU DON'T HAVE THIS PROBLEM WITH A GOOD NO CORE CABLE
NEED (2) TWO PAIRS OF VISE GRIPS
HOLDING CABLE WITH ONE USE A 3/8" CENTER PUNCH TO SPREAD THE CABLE A LITTLE BIT
THEN USEING A LITTLE LOCKTITE ON THE MALE SPLICE THREADS ONE SIDE ONLY TO START INTO THE END OF CABLE
IMPORTANT ONLY JUST GET STARTED INTO CABLE
THEN GRIP WITH ONE PAIR OF VISE GRIPS
WITH (2) SECOND PAIR GRIPPING THE OTHER CABLE GET IT STARTED
AND SLOWLY SCREW BOTH SIDES TOGETHER TILL THEY MEET !
THAT IS HOW PROFESSIONAL DRAIN PEOPLE DO IT
__________________
Pages: [1]